Argox OS-2130D Uživatelský manuál stáhnout pdf (Strana 37)

OS-2130D & OS-2130DE User’s Manual

at that left.

15. Plug the sensor board’s connector into the PCB's header

connector (J2).

16. Secure back the screw on the left bracket of the chassis.

17. Guide the sensor cable connector through the hole on the upper

left corner of the middle cover.

Figure 6.7

Screw

Dispenser bar

White plastic roller

Shaft

OS-2130D & OS-2130DE User’s Manual

18. Click the top cover back to the middle cover.

19. Insert the sensor connector into its receptacle on the main logic

board of the base housing.

20. Click the middle cover back to the base housing. First click in the

front part then the rear.

21. Secure the two screws at the bottom of the base housing.

Figure 6.8

4mm Gap

Middle Cover

H. Cover

1 2 ... 32 33 34 35 36 37

Žádné komentáře

Argox OS-2130D Uživatelský manuál Strana 37